Brandon Wilson revient avec cette fois-ci un homebrew PSP qui permet, une fois branché à la PS3, de passer la PSP en "JIG" pour ainsi passer la PS3 en Factory/Service mode et ainsi downgrader les PS3.Attention, ne tentez pas de downgrader une console 3.56, vous resteriez coincé dans le mode Factory/Service sans pouvoir en sortir.
Regardez la page suivante pour savoir comment downgrader la PS3 avec PS3Jig pour PSP.
Voici la FAQ fournie avec:
What's the main purpose of this?
To enter Factory/Service Mode on your PS3 using your PSP. This is typically used to downgrade your PS3's firmware version to something that supports homebrew/backups, or you can use it to unbrick some PS3s from a firmware flash gone bad.
Will this cause any permanent damage to my PSP?
Not that I know of, but don't blame me if it does.
Do I need a special cable for this?
No, you just need a standard A<->mini-B USB cable. Among many other uses, it's the cable used to charge/sync PS3 controllers. You have one of these.
What firmware version does my PS3 need to be on for this to work?
As of this writing, you need to be on firmware version 3.55 or earlier. DO NOT USE IT ON FIRMWARE VERSION 3.56 OR HIGHER UNTIL YOU READ OTHERWISE ELSEWHERE.
What firmware version does my PSP need to be on for this to work?
Honestly, I don't know. This requires kernel mode, so as of this writing (and to the best of my knowledge), version 6.35 or lower. It runs on my PSP-1001 5.50 GEN-D.
I get an error when I run it on the PSP! What's wrong?
I really don't know.
How do I get this on my PSP?
The same way you do with any other PSP homebrew. Do some reading and/or googling.
It didn't work! What's wrong?!
Try it multiple times. I have noticed through a hardware USB analyzer that sometimes the PSP doesn't send the jig challenge response correctly, despite the PSP saying it did.
Will this work on the PSP Slim? 2000? 3000?
I honestly don't know.
It locked up my PSP when I tried to exit! Why?
I honestly don't know. Pull the battery, re-insert it, and turn it back on.
What tools did you use to compile/build this?
PSPSDK.
Where's the latest source at?
http://brandonw.net/svn/pspstuff/PS3Jig/trunk/.
What dongle ID does this use?
0xAAAA. It can easily be changed and re-compiled in the source. I didn't provide a UI for it because it's unlikely anyone will ever need to change it.
I thought you said this couldn't be done! And yet here it is, prick. What's with the lying?
I said you couldn't implement the PSGroove/PSJailbreak exploit on it, and that's still true. Emulating the Sony official jig stick for Factory/Service Mode is different, and the PSP can do it. I didn't see anyone else doing it, so I did.
Télécharger PS3Jig - PS3 Factory/Service Mode "Jig" Dongle via PSP
Site officiel : http://brandonw.net/psp/ps3jig/Code source : http://brandonw.net/svn/pspstuff/PS3Jig/trunk/
Flux RSS