Here is what's happen :
I had jailbroken my ps3 like 4 months ago and put it in DEX (rebug) right after jailbreaking it. Everything was working perfectly until last week, when I toke my dump/bio of my ps3 with multiman and modified my mac address.
I most did something wrong because once I re-injected my modified dump in multiman and then quit to XMB, I got a black screen so I had to unplug my console.
Since this, everytime I started my ps3, my ps3 was shuting down by itself after 3 secondes with a yellow light (yellow light duration was like 0.4secondes) and then a flashing red light until i pressed again the power button (once pressed again the flashing red light, the red light stopped flashing and when pressed again, the ps3 started up and suted down after 3sec...ect..).
My ps3 (slim cech 20) was obliviously bricked so I open it up to solder the Nor-Tristate to the SBE point of the e3 clip.
But, I really suck at soldering and what i soldered broke before i even got time to inject my valid dump.
I really don't know why but since I did try to solder, my ps3 was no more doing the kind of ''YLOD'' brick but was still shutdown by itself after something like 15-20 secondes (during the 10-20secondes, the ps3 was normal for like 7 secondes then the fan was going louder and louder until the ps3 shutdown).
So I tried to fix the problem by resoldering the cable from the Nor-Tristate to the SBE point of the e3 clip and this time I success and the soldering didn't break.
BUT...
When I put all my ps3 back together and was ready to test it, the power/eject board was not lighting up (both power and eject buttons) and was also not working !
Before my last attempt to solder my ps3, the power/eject board had always been working and I didn't did anything wrong/special on it for it to be broken like that!! (
I would really be so much glad if someone help me, I put a lot of time and money in my ps3 and would really want to make it work again.
First if someone could help me finding from were is the problem it would be nice (from the power/eject board itself or maybe the motherboard that as been domaged during the soldering).
Also I thing it's importent to precise that since I'm really ****ing bad at soldering, when i tried to solder my cable on the Tristate point on my motherboard (the second time), the little tiny metal piece where you suppose to solder your cable had broke and fall (i lost it) but i replace it with some metal that i solder at the same place that this metal piece was.
Thanks in advance for your incomming help and sorry for my bad english, I hope you understood
PS : I got pretty much everything that someone need to fix his ps3 as I read from the most of the ylod/brick problem ( I mean e-stta station, e3 clip, e3 flasher, e3 dongle, solder material, valid dump, ect)
Etienne
Flux RSS